Free Download Cisco 350-001 VCE Test Engine Full Version Now (271-280)

QUESTION 271
When troubleshooting duplex mismatches, which two are errors that are typically seen on the half duplex end? (Choose two.)

A.    excessive collisions
B.    FCS errors
C.    runts
D.    late collisions

Answer: BC
Explanation:
http://www.netcordia.com/resources/tech-tips/switch-port-duplex-mismatch.asp

QUESTION 272
You are using VTP (version 2) in your network to transport VLAN information between switches. When adding a switch to the network (that has been used in the lab previously), you notice that a lot of the existing VLANs have been deleted or replaced with other names. What can you do to prevent this from happening in the future, without losing all VTP features that you are using today?

A.    configure a hard-to-guess VTP domain name
B.    use a hard-to-guess VTP password
C.    use VTP transparent mode
D.    implement VTP version 3

Answer: D
Explanation:
http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps708/solution_guide_c78_508010.
html

QUESTION 273
Which two combinations are valid PAgP configurations that will set up a PAgP channel? (Choose two.)

A.    On-Passive
B.    On-Auto
C.    Passive-Active
D.    Desirable-Auto
E.    Active-Active
F.    Desirable-Desirable

Answer: DF
Explanation:
http://www.cisco.com/en/US/products/hw/switches/ps607/products_configuration_example09186 a0080094789.shtml (see port aggregation protocol)

QUESTION 274
Which three causes could prevent a host from getting an IPv6 address with stateless autoconfiguration? (Choose three.)

A.    The autoconfig command is missing from the router interface.
B.    IPv6 multicast routing is not enabled on the router interface.
C.    IPv6 unicast routing is not enabled on the router interface.
D.    The router interface is configured with a /63 mask.
E.    The router interface is configured with a /65 mask.

Answer: CDE

QUESTION 275
Which two IPv6 address pairs can be assigned on a point-to-point link with a /125 mask? (Choose two.)

A.    2001:DB8::1 and 2001:DB8::2
B.    2001:DB8::9 and 2001:DB8::10
C.    2001:DB8::10 and 2001:DB8::17
D.    2001:DB8::1 and 2001:DB8::18

Answer: AC

QUESTION 276
Which two of the following are considered valid router IDs for EIGRPv6? (Choose two.)

A.    0.0.0.1
B.    0.255.0.1
C.    2001:DB8::1
D.    2001:DB8:ABCD:FEEF::1

Answer: AB

QUESTION 277
Which two tunneling techniques in IPv6 do not require an IPv4 tunnel destination in the configuration? (Choose two.)

A.    6to4
B.    6over4
C.    ISATAP
D.    GRE

Answer: AC

QUESTION 278
Refer to the exhibit. Which statement is correct?

image
A.    Router CE1 is waiting for the query for the prefix 55.55.55.55/32 to be acknowledged.
B.    Router CE1 is waiting for the reply for the prefix 55.55.55.55/32 to be received.
C.    Router CE1 still has to send out a query for the prefix 55.55.55.55/32.
D.    Router CE1 has sent out a reply that has not been acknowledged yet.

Answer: B
Explanation:
If you see the remaining replies, you will know that CE1 is waiting for the reply from 55.55.55.55/32.

QUESTION 279
When a BGP router is not capable of understanding 4-byte AS numbers, it will see 4-byte AS numbers as a special, reserved, 2-byte AS number in the AS path. Which 2-byte AS number is this reserved one?

A.    00000
B.    12345
C.    23456
D.    65000
E.    99999

Answer: C
Explanation:
http://www.cisco.com/web/about/security/intelligence/4byte-as.html

QUESTION 280
What are the “bound IP addresses” used for in LDP?

A.    For each such address and mask /32, one label binding is created.
B.    As the TCP endpoint, IP addresses are used by the LDP session.
C.    These addresses are used to find the label binding to put in the LFIB, by looking up these IP
addresses in the routing table.
D.    These addresses are used for penultimate hop popping (PHP) when forwarding packets to the
next router directly.

Answer: C
Explanation:
In case of liberal label retention Label Information Base (LIB) maintains remote binding information through down streaming or through upcoming hop. The label binding is utilized in Label forwarding information base (LFIB) but no other labels are kept which are not used for forwarding packets. The cause for storing remote binding in LFIB is subject to topological change and implementation of dynamic routing due to downlink of router. Conservative label retention mode configure on an LSR does not contain all remote bindings except an associated upcoming hop in its LIB. However LLR will help in rapid routing topological change while CLR utilizes memory efficiently.

If you want to pass Cisco 350-001 exam successfully, donot missing to read latest lead2pass Cisco 350-001 practice tests.
If you can master all lead2pass questions you will able to pass 100% guaranteed.

http://www.lead2pass.com/350-001.html

Comments are closed.