[May 2018] Easily Pass Cisco 210-065 Exam With Lead2pass Latest Cisco 210-065 Brain Dumps 354q
Exam 210-065 PDF Free Instant Download From Lead2pass:
https://www.lead2pass.com/210-065.html
QUESTION 21
Which CLI command can be used to reset the Cisco TelePresence System 500-32 personal video system to a factory condition?
A. utils factory reset 2
B. utils system factory init
C. xcommand defaultvalues set level: 2
D. xconfiguration default factory
E. utils reset factory
F. xcommand SystemUnit FactoryReset
Answer: B
QUESTION 22
The C-Series endpoint (codec) does not register with the Video Communication Server that is located in a different network. Based on the exhibits, what could be causing the issue?
A. The subnet mask on the codec is incorrect.
B. The ip address of the codec is incorrect.
C. The interface that the codec is in is in the wrong VLAN.
D. The codec did not receive a DHCP address from the DHCP server.
Answer: A
Explanation:
The subnet mask configured on the codec is 255.255.255.128, when it should be 255.255.255.0.
QUESTION 23
Which three of these are functions of the Cisco TelePresence Management Suite? (Choose three.)
A. automatic software update and release keys
B. intelligent call routing engine
C. provisioning a Cisco TelePresence System endpoint
D. tracing SIP and H.323 calls
E. managing phonebooks for endpoints that are registered to the Cisco Unified Cisco Unified Communications Manager
F. rebooting endpoints that are registered to the Cisco TelePresence Video Communications
Server
Answer: ABF
QUESTION 24
Refer to the exhibit. Which system tab can be used to add video infrastructure devices and endpoints?
A. Navigator
B. System Overview
C. Configuration Templates
D. Provisioning
E. Administrative Tools
Answer: A
QUESTION 25
Which two layout or switching modes are supported with the Cisco TelePresence Multipoint Switch? (Choose two.)
A. enhanced continuous presence
B. active speaker switching
C. continuous presence
D. speaker switching
E. room switching
F. active continuous presence
Answer: DE
QUESTION 26
Which Cisco TelePresence Multipoint Control Unit Layout view mode gives prominence to one conference participant over the other conference participants while still allowing conference participants to view multiple participants at the same time?
A. enhanced continuous presence
B. active speaker
C. continuous presence
D. room switching
E. speaker switching
Answer: A
210-065 dumps full version (PDF&VCE): https://www.lead2pass.com/210-065.html
Large amount of free 210-065 exam questions on Google Drive: https://drive.google.com/open?id=0B3Syig5i8gpDTERGM2szMlVfSTQ
You may also need:
210-060 exam dumps: https://drive.google.com/open?id=0B3Syig5i8gpDN25QVlRta3F0UkE