Latest CCIE 350-001 New Question (81-85)

admin July 5, 2013 350-001 Dumps Comments Off on Latest CCIE 350-001 New Question (81-85)

QUESTION 81

Refer to the exhibit. What problem does the debug ip ospf event output from R3 indicate?

A.209.165.202.140 and R3 are not both configured as OSPF stubs.

B.209.165.202.140 and R3 are not configured in the same OSPF area.

C.209.165.202.140 is configured as a no-summary stub.

D.Transit area OSPF hello packets are not processed by design.

Answer: A

QUESTION 82

Refer to the exhibit. R4 is configured as an OSPF stub; however, R4 should still be learning the OSPF LSA type 3 interarea routes from 209.165.202.130. Which action will solve this issue?

A.Remove any route maps from R4 that are filtering the incoming OSPF updates.

B.Enable sending summary LSA’s by removing no-summary from the stub command on the ABR.

C.Enable sending summary LSA’s by removing no-summary from the stub command on the ASBR.

D.Control of interarea route propagation is best handled with EIGRP.

Answer: B

QUESTION 83

Refer to the exhibit. An OSPF virtual link is configured between R4 and R3. Based upon the show command output, why is the virtual-link down?

A.Virtual links cannot transit area 0.

B.The cost of the virtual link needs to be configured as 1.

C.The timer intervals for virtual links need to be aggressive (2, 8, 8, and 1).

D.The virtual interface VL1 is shut down.

Answer: A

QUESTION 84

Refer to the exhibit. An OSPF virtual link is configured between RTB and RTA. Based upon the exhibit, why is the virtual link on RTB down?

A.The cost on each end of the OSPF virtual link must be identical.

B.There is a unidirectional physical layer issue from RTB to RTA.

C.The OSPF virtual link neighbor IP address on RTB is incorrect.

D.The virtual link state on FastEthernet0/0 of RTA must be point-to-multipoint.

Answer: C

QUESTION 85

Refer to the exhibit. Router 1 has three OSPF neighbors, but none of them have routes to the 10.10.10.0 network. Why?

A.A metric is not defined on the redistribute statement.

B.Redistribution cannot be done in a non-zero area.

C.The subnets keyword should not be used.

D.Area 1 is a stub area.

E.Area 1 is a not-so-stubby area.

F.A route map must be used on the redistribute statement to permit the 10.10.10.0/24 route.

Answer: D

…

Want to see the full version? please visit http://www.lead2pass.com/350-001.html

Comments are closed.