QUESTION 111 Refer to the exhibit. Catalyst R is the root bridge for both VLAN 1 and VLAN 2. What is the easiest way to load-share traffic across both trunks and maintain redundancy in case a link fails, without using…Continue Reading →
QUESTION 101 Which two of these are used in the selection of a root bridge in a network utilizing Spanning Tree Protocol IEEE 802.1D? (Choose two.) A. Designated Root Cost B. bridge ID priority C. max age D. bridge ID…Continue Reading →
QUESTION 91 Refer to the exhibit. Which of the following options will trigger the applet? A. an external Cisco IOS event B. a manually run policy event C. a preconfigured timer D. an automated RPC call Answer: B
QUESTION 81 Refer to the exhibit. What problem does the debug ip ospf event output from R3 indicate? A. 209.165.202.140 and R3 are not both configured as OSPF stubs. B. 209.165.202.140 and R3 are not configured in the same OSPF…Continue Reading →
QUESTION 71 While you are troubleshooting network performance issues, you notice that a switch is periodically flooding all unicast traffic. Further investigation reveals that periodically the switch is also having spikes in CPU utilization, causing the MAC address table to…Continue Reading →
QUESTION 61 Refer to the exhibit. Why is AS 65333 in parentheses? A. It is an external AS. B. It is a confederation AS. C. It is the AS of a route reflector. D. It is our own AS. E. …Continue Reading →
QUESTION 51 What is the flooding scope of an OSPFv3 LSA, if the value of the S2 bit is set to 1 and the S1 bit is set to 0? A. link local B. area wide C. AS wide D. …Continue Reading →
QUESTION 41 Which two are effects of connecting a network segment that is running 802.1D to a network segment that is running 802.1w? (Choose Two.) A. the entire network switches to 802.1D and generates BPDUs to determine root bridfe status….Continue Reading →